To calculate the position and orientation of the upstands

Ø        Choose Calc Upstands from the Stringer menu

The upstands will be generated and displayed as a short line in the direction of the stringer orientation at the intersection between each stringer and each frame in the design.

If Upstands are not visible, choose the Structure command from the Display menu and turn on the Upstands box.

Note that to ensure that the direction of the upstands is correct relative to the surface, you should check the direction of the surface Check Outside Arrows (see page 9 of this manual). The arrow should point in the opposite direction as the upstands.